Constraints of hole larger than 0.889mm

Upverter Support Layout Editor
#1

Hi,
I have many constraints of ‘hole larger than 0.889mm’, I’m new in this world and I don’t know how to treat that, how to take care with those constraints?

All the best,

#2

Hi,

If you go to the CONSTRAINTS section in the top panel. You’ll find every rules defined in your project.
You can modify hole constraint by editing Hole Size.

It is recommended to look at manufacturer capabilities before modifying any of these constraints.

Sebastien Laniel

1 Like
#3

Thanks @slanAlphaMach. Really appreciate helping out the community!