Pour issue with newly updated upverter

Upverter Support Layout Editor
#21

I have the same issue, but somehow you can access your design if you fork it.

1 Like
#22

That’s extremely helpful!
Thanks a lot kjeldsm
Regards,
Wade

#23

Wade,
Your design should be fine now. Sorry for inconveniences,

#24

kjeldsm,
your design should also be fine now.

#25

When the pour is not connected to anything it considered to be a “dead copper” and got removed with islands removal. If you connect it to a net, and place a PTH the pour will be handled by the engine.

1 Like
#26

Aha! I guess an empty set of points is a logically consistent but surprising behaviour for a disconnected pour where island removal is enabled. But it’s quite startling - it might result in similar bug reports from others in future…

FWIW, the actual behaviour doesn’t appear to be an empty set/null pour, but a failed pour with a blue border showing as ‘un-poured’ on the constraint violation list. Intentional? (Perhaps friendlier that a genuinely empty set happening, as it’d be quite hard to ‘visually select’ an entirely empty pour.)

#27

Hi nalivaiko,
Thanks for your reply.
There is another issue in design 544fc9025cccdad2.
When “Drill Chart CSV-formatted drill chart” is to be exported, I’ve got the following.

500 Server Error

There was an error processing your request.

Can this be resolved?
Regards,
Wade

#28

Wade, we are on it :slight_smile:

1 Like
#29

@WeiDaZhang - Hi Wade, just checking that all is working now. Thanks

#30

I still have issues with both by GND pour, I continuously get "The tool experienced an error"and then the design reloads. Here my design ID: 413e253dafb50271

#31

Hi Stefan - do you get this error only when you perform a polygon repour? We will investigate.

Also in the meantime could you please check with a different browser like chrome or firefox.

Thanks